MODEL: With this form you can create by yourself the drawing for an ESCALATOR model S, that mean for commercial use (trade center, shop etc).

INCLINATION ANGLE: Available choose are 30° and 35°. The most popular on the market is 35°. The inclination angle 30°, is more elegant and is also the only choose for rise greater than 6 meter, according to the European EN115 (keep attention on this rule, otherwise the drawing will be not available).

HORIZONTAL STEPS:  Available choose is 2 or 3 horizontal steps on top landing and bottom landing. The most common choose is to combine an inclination angle of 35° with 2 horizontal steps on landings. Is never forbitten to choose an higher number of horizontal steps. On the other hand 3 steps have to be choosen for rise greater than 6 meter and have to be combined with an inclination angle of 30° (keep attention on this rule, otherwise the drawing will be not available).

VERTICAL RISE:  The vertical rise is the difference in height between the finish floor level at its lower end and the finish floor level at its higher end. If this dimensions is higher than 6 meter is necessary to fill the form following the above points.

STEP WIDTH: Available choose is 600mm, 800mm e 1000mm. The online drawing are only available for step width of 800mm (total width of 1345mm) and 1000mm (total width of 1545mm).

ARRANGEMENT: Single layout is one unit that can be used alternative in up or down direction. Parallel layout are two units with parallel arrangement that are often used one for up direction and one for down direction. 

STARTING SYSTEM: If VVVF is selected an extension of 500mm of the top room machine is required, this is the reason why since the beginning, is necessary to know if this accessories is necessary.

ANTI-SEISMIC MOVEMENT: Upper and lower supports are designed to satisfy any building requests. The movement size should be decided from structural engineer .